WARNING: Once a license is assigned to a database, it is non-transferable. So before licensing any Offline or Production databases, we highly recommend requesting a DEMO license to test accessing the Exchange databases to ensure the desired messaging information can be accessed.
AND READ THIS IMPORTANT INFORMATION: DigiScope identifies databases
by markers that are unique to each database and will not change. One
of these markers is the database's Globally Unique Identifier (GUID).
However there is one case where the database's GUID will change: if you mount the database within an Exchange Recovery Storage Group (RSG) or as an Exchange Recovery Database (RDB). When you do this, Exchange assigns a new GUID to the recovered database to ensure it does not clash with a live production copy of the same database. When this change occurs, DigiScope sees the database as a new database and will require an additional license for it.
You may use RSGs or RDBs within Exchange to recover databases to disk, but, to avoid this issue, be sure to configure the recovery job not to mount the database upon completion. Only use DigiScope to mount the recovered database.
NOTE: If you are running DigiScope® on a system with no internet access, you will need to perform your license request manually via Web License Portal. Please refer to Request Full Product License Manually via Web License Portal for help on manually requesting a full license.
NOTE: All license requests sent via email will be processed between 8am and 6pm (Pacific Standard Time), Monday through Friday, excluding public holidays. Therefore, if possible, we highly recommend that you make all Licenses requests via the Lucid8 Online License Service.
order to request a license for specific databases, you must have first
obtained a DEMO license and added those databases to the DigiScope® Offline
or Production tree. For information on how to add databases, please
Adding and Removing an Offline Source
Adding and Removing a Production Source
After following the instructions within Request Full Product License Manually via Email, the On-Demand Licensing page is displayed. Check the Request Manually option, then select the Project Based option from the drop-down menu. Next, check the Send Email box. Now, click the Next > button to continue.
NOTE: You may also optionally check the Print out a copy of your license information for record keeping purposes option. This option will prompt you to print a copy of your license request information so you may keep a record of the request.
Next, the Project Based License Store/Database Selection page is displayed. Check the stores/databases that you wish to request the Specific - Project Based license for, then click the Next > button to continue.
The License Request Wizard will now attempt to email your request to Lucid8 for processing.
If no issues were encountered while sending the request, this should take you to the end of the License Request Wizard. Click the Finish button to end the License Request Wizard.
NOTE: If DigiScope® cannot establish a proper SMTP connection, the attempt to send the email will fail and therefore you will have to manually send the license request file to DigiScopeLicReq@lucid8.com or use the Lucid8 Web Licensing Portal which is available 24x7x365 .
Continue to Installing a License if you have not already installed the license received via email
Continue to the Configuration